Nauru Pleat Plus R High Flow Cartridge Filter

Pleat Plus R High Flow Filter is manufactured to replace Pentair Aqualine high flow filter, it fits well in original Aqualine FRP housing. This filter is constructed with polypropylene filter media and inner core, 6.75 inch (171.5 mm) diameter provides high flow rate and reduces filter usage, which can greatly lower capital cost and operating cost. Due to high quality materials, Pleat Plus R high flow filter offers lower pressure drop, less filter change-out and superior particle retention performance, making it an ideal option for protection of downstream membrane system.

Category:

NauruHigh Flow Filter

Phone:400-888-8888

Inquire

Product Description

Pleat Plus R High Flow Filter is manufactured to replace Pentair Aqualine high flow filter, it fits well in original Aqualine FRP housing. This filter is constructed with polypropylene filter media and inner core, 6.75 inch (171.5 mm) diameter provides high flow rate and reduces filter usage, which can greatly lower capital cost and operating cost. Due to high quality materials, Pleat Plus R high flow filter offers lower pressure drop, less filter change-out and superior particle retention performance, making it an ideal option for protection of downstream membrane system.

Features

　　● Outside to inside structure enhances the flow rate

　　● Big outside diameter reduce change-out time

　　● Multi membrane layer increases removal efficiency

　　● Special pleated design increases the dirt holding capacity

　　● High surface area

　　● Long service life

Application

　　● Pre-RO

　　● Micro electronics process water

　　● Chemical solvents

　　● Drinking water treatment

　　● Cooling water

　　● Food & Beverage

　　● Oil&Gas

Specification

Materials of Construction
Filter Media	Polypropylene
End Caps	Polypropylene
Inside Core	Polypropylene
Outside Core	Netting
O-Rings	Silicone/EPDM/NBR
Dimensions(Nominal)
Nominal Outside Diameter :	6.73inch/171(mm)
Nominal Inside Diameter :	2.99inch/76mm
Length	40inch(1016mm)/60inch(1560mm)
Micron Ratings	1μm,3μm,5μm,10μm,20μm, 30μm,50μm,75μm,100μm
Operating Condition
Maximum Temperature:	Polypropylene 180 ℉ (82 ℃)
Maximum Pressure:	49psi (3.4bar) @ 68 ℉ (20 ℃)
Recommended change-out pressure:	35psi (2.4bar) @ 68 ℉ (20 ℃)