Hyflux Membrane Retrofit

Fluoro-Pure D600ER Series UF filter is developed to replace Hyflux UF Membrane Kristal K600ER model, providing a more economical replacement solution and making sure retrofit module is 100% compatible with existing UF system.

Made with hollow fiber PVDF membrane, Fluoro-Pure D600ER provides excellent strength thus making sure less fiber breakage, meanwhile, PVDF material is suitable for high concentration chlorine cleaning.

It allows for cross-flow and dead-end filtration, 0.03μm pore size contributes to good rejection to contaminants as well as offering high flow rate.

Membrane Materials Comparison
	PAN	PES	PVDF
Membrane strength	Poor	Good	Excellent
Membrane elongation	Poor	Good	Excellent
Anti-fouling performance	Poor	Excellent	Excellent
Chemical resistance(NaClO)	Poor	Good	Excellent
Temperature resistance	Good	Excellent	Excellent
Membrane cost	Excellent	Good	Good

Features

　　● PVDF membrane with better chemical performance than PES

　　● Direct replacement for Hyflux K600ER UF Membrane

　　● Operation same as Hyflux Kristal membrane

　　● Outside-in flow mode

● Good flow recovery after cleaning

Typical applications

Palm oil effluent treatment Steel effluent treatment

Refinery plant effluent treatment Textile and dyeing effluent

Specification

Model		DFPVDF600ER
Specification	Membrane material	PVDF
	Housing material	UPVC
	MWCO(Dalton)	120,000
	Inner diameter(mm)	0.7
	Outer diameter(mm)	1.3
	Membrane area(m2)	60
	Overall length(mm)	2,130
	Module diameter(mm)	257.8
	Feed/Filtrate port	1.5 inch NPT
	Rejection port	1 inch NPT
	Potting material	Epoxy resin
	Bacteria rejection	>99.9999%
	Virus rejection	>99.99%
	Tensile force(N)	>3
Operation parameter	Max.chlorine concentration(ppm)	2000
	pH range	2 - 11
	Max backwash pressure(Mpa)	0.2
	Max feed pressure(Mpa)	0.25
	Max backwash flow(L/H)	3500
	Air scour rate(Nm3/h)	4.0 - 7.0
	Design flux(LMH)	50 - 120

FAQ:

Q: When I used UF membranes, main problem is fiber breakage, how is your membrane?

A: Generally there are three causes for fiber breakage:First is abrasion by small particles during air scour, Second is high hydraulic stress to fibers due to too high flux, third is membrane mechanical fatigue. DELTA PVDF fiber has excellent tensile strength and can be applied to high chlorine concentration chemical cleaning, our design and technical team will guide you appropriate design for pretreatment to minimize fiber damage caused by fine particles, and suggest most optimized design flux for UF membrane, fiber breakage is not an issue for our modules.

Q: How is your recovery rate? Can I go to 95% or higher recovery?

A: We decide recovery rate by feed water quality analysis and overall process treatment, take ground water as feed water source, usually it is no higher than 90%, we should be aware that even though higher recovery means higher flux and less modules, it is also a main cause for membrane clog.

Q: Do you provide OEM service for UF modules?

A: Yes, DELTA positions itself as an OEM manufacturer for filtration products with fast delivery time, any OEM request is welcome.

Send Inquiry

Contact

Category:

Ultrafiltration Membrane

Keywords:

Roll Membrane | High Flow Filter | PP Pleated Filter

Tel: +86-513-89157856
Email: sales@delta-filtration.com

Fluoro-Pure D600ER Series UF filter is developed to replace Hyflux UF Membrane Kristal K600ER model, providing a more economical replacement solution and making sure retrofit module is 100% compatible with existing UF system.

Product Description

It allows for cross-flow and dead-end filtration, 0.03μm pore size contributes to good rejection to contaminants as well as offering high flow rate.

Membrane Materials Comparison
	PAN	PES	PVDF
Membrane strength	Poor	Good	Excellent
Membrane elongation	Poor	Good	Excellent
Anti-fouling performance	Poor	Excellent	Excellent
Chemical resistance(NaClO)	Poor	Good	Excellent
Temperature resistance	Good	Excellent	Excellent
Membrane cost	Excellent	Good	Good

Features

　　● PVDF membrane with better chemical performance than PES

　　● Direct replacement for Hyflux K600ER UF Membrane

　　● Operation same as Hyflux Kristal membrane

　　● Outside-in flow mode

● Good flow recovery after cleaning

Typical applications

Palm oil effluent treatment Steel effluent treatment

Refinery plant effluent treatment Textile and dyeing effluent

Specification

Model		DFPVDF600ER
Specification	Membrane material	PVDF
	Housing material	UPVC
	MWCO(Dalton)	120,000
	Inner diameter(mm)	0.7
	Outer diameter(mm)	1.3
	Membrane area(m2)	60
	Overall length(mm)	2,130
	Module diameter(mm)	257.8
	Feed/Filtrate port	1.5 inch NPT
	Rejection port	1 inch NPT
	Potting material	Epoxy resin
	Bacteria rejection	>99.9999%
	Virus rejection	>99.99%
	Tensile force(N)	>3
Operation parameter	Max.chlorine concentration(ppm)	2000
	pH range	2 - 11
	Max backwash pressure(Mpa)	0.2
	Max feed pressure(Mpa)	0.25
	Max backwash flow(L/H)	3500
	Air scour rate(Nm3/h)	4.0 - 7.0
	Design flux(LMH)	50 - 120

FAQ:

Q: When I used UF membranes, main problem is fiber breakage, how is your membrane?

Q: How is your recovery rate? Can I go to 95% or higher recovery?

Q: Do you provide OEM service for UF modules?

A: Yes, DELTA positions itself as an OEM manufacturer for filtration products with fast delivery time, any OEM request is welcome.

Related Products

Brackish Water Reverse Osmosis

Delta Filtration brackish water ro membranes are specially developed for brackish water filtration process with TDS range 1000~5000 mg/L, standard size 4inch / 8inch diameter and 40inch length, OEM service is available.

Low Pressure Reverse Osmosis

Delta Pure reverse osmosis low water pressure membrane element is developed for energy saving applications with low operation pressure. It has the characteristics of high flow and excellent rejection performance in salt rejection. It is especially suitable for the preparation of ultra pure water in Pharmaceutical, Electronics and Power industry etc. DFLP8040 has large filtration area of 37m2 with 99.5% stable salt rejection rate.

Sea Water RO

Delta Filtration seawater RO membranes are manufactured under ISO 9001 management system, 100,000 pcs annual production capacity for industrial RO guarantees fast delivery time from Shanghai port.

Dow IP-51XP IP-77XP Alternative

Fluoro-Pure DelPac Series Ultrafiltration module can be used as replacement for Dow IntegraPac membrane IP-51XP, IPD-51XP, IP-77XP and IPD-77XP series with compatible dimensions, PVDF hollow fiber UF membrane applies outside-in flow mode, it allows for wide range of feed water, making it a robust UF module.

Dow UF Membrane Retrofit

Fluoro-Pure DFP Series Ultrafiltration module is developed to replace Dow Ultrafiltration Membrane SFP 2860 and 2880 with same dimensions and operation principle, compared with PES, PVC and PAN materials, PVDF has much better resistance to chemicals especially sodium hypochlorite-which is main chemical used for membrane cleaning.

Dow IP-51 IP-77 Alternative

Fluoro-Pure DelPac Series Ultrafiltration module is developed to replace Dow IntegraPac membrane IP-51 and IP-77 cross flow ultrafiltration filter with compatible dimensions at much more economical price, compared with PES, PVC and PAN materials, PVDF has better tensile strength and much better resistance to chemicals especially sodium hypochlorite-which is main chemical used for membrane cleaning.

Ultrafiltration DFPVDFMAX60

Delta Filtration Ultrafiltration module DFPVDFMAX60 is equivalent to Hydranautics HYDRAcap MAX 60 UF membrane, with PVDF membrane of pore size 0.03μm, DFPVDFMAX60 can provide superior retention performance and offer log 4 rejection of Giardia cysts and Cryptosporidium oocysts.

Retrofit For 3M Liqui-Flux

Fluoro-Pure DFPESW10-75 Ultrafiltration module is made with hollow fiber Polyethersulfone(PES) membrane which is naturally hydrophilic and suitable for liquid filtration, it can be used to replace 3M MEMBRANA Liqui-Flux W10 Series UF membrane modules with better cost effectiveness.

Fluoro-Pure DELWED PES Module

Fluoro-Pure DELWED Ultrafiltration module is an economical membrane element with hydrophilic PES membrane design and robust hollow fiber structure, as an integrated membrane technology provider, we have strict quality control procedure and internal test to make sure Delta module provides equivalent performance to leading brands. With 0.02μm pore size, DFPES700B-60 can effectively retain particles, bacteria and virus and produce clean water which makes is suitable for drinking water treatment, pre-treatment for reverse osmosis, industrial wastewater treatment etc.

Retrofit For Koch Targa II Cartridge

Pentair X-Flow Aquaflex Retrofit

Fluoro-Pure DELFLEX Series Ultrafiltration module is made with hollow fiber Polyethersulfone(PES) membrane which is naturally hydrophilic and suitable for liquid filtration, it can be used to replace Pentair UF membrane or Norit UF Aquaflex Series PES UF membrane modules with better cost effectiveness.

Inge VK-0094 Dizzer 5000plus Retrofit

Fluoro-Pure DFPES700B-50 Ultrafiltration module is an economical replacement for Inge dizzer XL 5000plus(p/n: VK-0094), as an integrated membrane technology provider, we have strict quality control procedure and internal test to make sure Delta module provides equivalent performance to Inge brand.